The second roundabout included the pathways included 3D design and visual communications. In the morningthe first job was to produce a small item made from wire using the spot welder to attach the wires. My first instinct was to produce a face from the wire although the end result was badly made (in my perspective).
18/09/2012
I decided to create a frame using the more rigid copper wire and used the other to create the first impresions of the face and finally to create a with the thin and malleable wire which was consricted by tying it around the the metal frame. The finale outcome however did come out fairly crude with little impression of a face that I wanted however it had looked good against the light as seen in the fourth photo
The second half of the day was dedicated to visual communications for this I had decided to use the image of a pair of fairly elaborate wrist watches that were contrasting white and black. We started by tracing over the image and then imprinting the image onto other media. After the glue dried it could then be torn off revealing the image printed on the new media
No comments:
Post a Comment